Xcd v50cr



Keywords: xcd v50cr
Description: Digital Video Camera Module Technical Manual XCD-V50CR XCD-V50 (Black and white model)  2005 Sony Corporation (Color model) A-C7X-100-11 (1) Table of Contents Overview Functions Control

Digital Video Camera Module Technical Manual XCD-V50CR XCD-V50 (Black and white model)  2005 Sony Corporation (Color model) A-C7X-100-11 (1)

Table of Contents Overview Functions Control Appendix XCD-V50CR XCD-V50 Main Features. 3 System Components. 4 Connection Diagram. 5 Location of Parts and Operation. 6 Gain. 7 Shutter. 7 Trigger Shutter. 7 16-bit Mode. 8 ExposureOut.

* The Institute of Electrical and Electronics Engineers, Inc. XCD-V50CR XCD-V50 Overview Main Features The XCD-V50 video camera module utilizes a 1/3-type PS IT CCD RAW mode output using the RGB Bayer pattern (XCD-V50CR only) High-speed digital interface IEEE1394b- 2002.

System Components The XCD-V50CR/V50 Video Camera Module system comprises the following components. Video Camera Module XCD-V50CR/V50 Host Adapter Card (Commercially available) XCD-V50CR XCD-V50 IEEE1394b Cable (9 pin-9 pin 4.5 m) Tripod Adapter VCT-ST70I (Isolated type) Overview C-mount Lens.

Connection Diagram XCD-V50CR/V50 C-mount Lens XCD-V50CR XCD-V50 IEEE1394b Cable Tripod Adapter VCT-ST70I Overview Host Adapter Card Host Equipment (PC, etc.)

Four screw reference holes of 3 can be used as the tripod adapor screw holes, too. Screw the tripod adaptor VCT-ST70I into the four screw holes when you use a tripod. XCD-V50CR XCD-V50 Rear Panel 4 IEEE1394b connectors Connect the IEEE1394b cable (supplied) to this connector.

1 (001h). 10 µ s 48 (030h). 0.99 ms 480 (1E0h). 10 ms XCD-V50CR XCD-V50 Functions Trigger Shutter Trigger shutter is useful for capturing images in response to a trigger that starts the exposure to match a preset timing.

The LOW period that is given by an output wave form is an approximate guideline. It does not correspond exactly to the actual exposure time. XCD-V50CR XCD-V50 White Balance (XCD-V50CR only) You can adjust the R and B gain with respect to G.

NodeID bbbbbbbb | bbnnnnnn | 11111111 | 11111111 | 11110000 | 11110000 | 00000000 | 00000000 XCD-V50CR XCD-V50 Control The remaining 28 bits can be allocated to the camera as addresses, but in reality, the first 2 bits are fixed at 0, so the largest number of bits that can be allocated to the camera as address space is 24 bits.

430h For offset address 424h, the length of the UnitDirectory is 3 Quadlets. UnitSpecID (00A02Dh) conforms to 1394TA standards. UnitSoftwareVersion (000102h) conforms to IIDC Standards, Version 1.3X. XCD-V50CR XCD-V50 8-15 16-23 24-31 ROM CRC 0003 The UnitDirectory offset address is required to be.

For offset address 474h, the length of the ModelNameLeaf is 4 Quadlets. The subsequent 8 bytes are fixed at 00. For the XCD-V50, the 7 characters “XCD-V50” come next. For the XCD-V50CR, the 9 characters “XCD- V50CR” come next. XCD-V50CR.

Based on the data above, the formats, modes, and frame rates supported are shown in the tables below. Video modes supported Format Mode ImageSize 640 × 480 640 × 480 XCD-V50CR XCD-V50 FrameRate PacketSize (bytes) ColorCoding Mono8 2560 1280 Mono16 × 2560 Control 3.75.

Address Data F0F00630h 08000000h (FrameRate) F0F00630h 0E000000h (VideoMode) XCD-V50CR XCD-V50 Starting/Stopping Video Transfer (ContinuousShot) In the device driver, after the preparations for receiving isochronous data are made, video transfer starts when the following commands are issued. Address F0F00614h When the following command is issued, video transfer stops.

Max. 3196 This feature exists. The value can be read out. Manual setting can be selected. 8-19 Min. 0 (XCD-V50) or 256 (XCD-V50CR) 20-31 Max. 256 (XCD-V50) or 768 (XCD-V50CR) This feature exists. The value can be read out. Feature can be switched between ON and OFF.

Outputs a software trigger. In Trigger Mode0, automatically reset to “0” when exposure ends. 00000000 In Trigger Mode1, ends exposure if “0” is set. XCD-V50CR XCD-V50 White Balance control (XCD-V50CR only) Address Data F0F0080C 82bbbrrr Sets R and B Gain.

Make sure that the following conditions are met when the trigger is activated. Mode 0: timing after the exposure set by the parameter is finished Mode 1: at the trailing edge of the trigger pulse T≥1/30 sec XCD-V50CR XCD-V50 Appendix.

C-mount Flange back 17.526 mm Minimum illumination XCD-V50CR: 20 lx (F0.95, Gain: +18 dB) XCD-V50: 4 lx (F0.95, Gain: +18 dB) Gamma γ = 1 (Fixed) Shutter 1/10000 to 1/15 s (at 15 fps) 1/10000 to 1/30 s (at 30 fps)

CCD Pixel Location (Top View) Total number of pixels: 692 (H) × 504 (V) Number of effective pixels: 659 (H) × 494 (V) Number of output pixels: 640 (H) × 480 (V) XCD-V50CR XCD-V50 Appendix.

Spectral Sensitivity (Relative Response) Parameters (Without lens and light source parameters.) XCD-V50 XCD-V50CR XCD-V50CR XCD-V50 Wave Length [nm] Wave Length [nm] Appendix 1000.






Photogallery Xcd v50cr:


Page 15 of Sony Camcorder XCD-V50 User's Guide | ManualsOnline.com


Page 18 of Sony Camcorder XCD-V50 User's Guide | ManualsOnline.com


Meldungen - JenCam


Patent WO2013171490A1 - Method for determining the amount of an ...


Old school bmx iron horse retro vw Buy, sale and trade ads


Campion lawnmower Buy, sale and trade ads - great prices


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Rehab-"why do I do" - YouTube


Patent WO2013171490A1 - Method for determining the amount of an ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2012170549A1 - Compositions, methods, and kits for ...


Patent WO2013171490A1 - Method for determining the amount of an ...


1122557100_oaf0101.jpg


Prsentation "LASMEA Clermont, le 25 janvier 2007 1 Mesure et ...


Prsentation "LASMEA Clermont, le 25 janvier 2007 1 Mesure et ...