Marmitek sc2800



Keywords: marmitek sc2800
Description: Wireless Smoke Detector (Type 3) Operating Instructions Version 1.2 For Marmitek alarm installations of the types: Homeguard MS8000, Security Systems: MS9470, MS9480 Security Systems: MS9770, MS9780

Wireless Smoke Detector (Type 3) Operating Instructions Version 1.2 For Marmitek alarm installations of the types: Homeguard MS8000, Security Systems: MS9470, MS9480 Security Systems: MS9770, MS9780 Base Stations: SC2700, SC2800.

Please read these instructions fully and completely before initial commissioning; they contain information for the correct installation of this innovative radio smoke alarm. © 2003 Convia GmbH, Germany All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher.

4. Installation places. 5 5. Installation. 8 6. Registering the smoke detector with the base systems/stations of the types: „MS9470“, „MS9770“, „MS9480“, „MS9780“, „SC2700“, „SC2800“. 10 7. Registering the smoke detector with the base station of the type „Homeguard MS8000“. 11 8.

1. General and function The optical smoke alarm is available as an optional extra for the Marmitek security systems of the types: Homeguard MS8000, security system MS9470/MS9480/MS9770/MS9780, Marmitek security system base station SC2700, SC2800. It can detect incipient low temperature fires and open fires with smoke development and should be in installed every room.

3. Safety- and m aintenance- references • Never open the equipment. It contains no parts to be waited. In the event of an error please give the smoke detector to your dealer. • Operate the equipment only in interiors and avoid the influence of dust, strong draft of air and direct sun light.

Recommended best and acceptable locations to mount smoke detectors: Locations for placing smoke detectors for single residence with only one sleeping area: Page 6 of 12.

Locations for placing smoke detectors for single floor residence with more than one sleeping area: Arrangement in a building with many floors. Page 7 of 12.

The smoke detector should be installed in the centre of the room, on the ceiling, or for a sloping roof at the highest point, as smoke rises and gathers in this area. This guarantees the earliest possible alarm warning. Smoke alarms should be installed in all rooms, but not directly above the cooking area in the kitchen or the bath, where dust concentrates.

• Using a 3/16-inch (5mm) drill bit, drills two holes at the marks and insert plastic wall plugs. Put the detector away from getting plaster dust on it when you drill holes for mounting. • Using the two screws and plastic wall plugs (all supplied) attach the bracket to the wall.

In the case of a fire emergency the smoke detector sends the alarm signal to the Marmitek alarm installation (it does not matter whether the base station is set to arm or disarm. The alarm will be triggered in both cases!)

In the case of a fire emergency the smoke detector sends the alarm signal to the Marmitek alarm installation (it does not matter whether the base station is set to arm or disarm. The alarm will be triggered in both cases!)

8. Final assembly The lower sect ion of the smoke detector is attached to the bracket already mounted on the ceiling and turned clockwise to the stop. 9. Convia smoke detector - technical data Frequency: 433.92 MHz Modulation: Range: Up to 30 meters (Free field. In combination with Homeguard the range is reduced) Alarm: 85 dB.






Photogallery Marmitek sc2800:


Page 20 of Marmitek Home Security System MS9970 User's Guide ...


Page 2 of Marmitek Home Security System MS9770 User's Guide ...


Marmitek DS10 x10 RF Door Window Magnetic Contact Sensor | eBay


Whome Pty Ltd -- Trusted supplier of home automation in Australasia


Page 11 of Marmitek Smoke Alarm SD90 User's Guide | ManualsOnline.com


Smoke Alarm - Users Guides "Smoke Alarm" | Page 48


INFORSECURITEL, S.L. - - (Seguridad y Defensa, Informtica y ...


Let's Automate. Home Automation, X10 Home Automation, Automation ...


X-10 Smoke Sensor - CSDD


X-10 Smoke Sensor - CSDD


X-10 Smoke Sensor - CSD


X-10 Flood Sensor - CWD


X-10 Smoke Sensor - SD90


Wireless Window Sensor


Wireless Window Sensor


INFORSECURITEL, S.L. - KIT DE CMARA INALMBRICA A COLOR Y SONIDO ...


cm15pro-pc-interface-x10.jpg


cm15pro-pc-interface-x10.jpg