Peugeot 206 16

For copyright infringement and removal of materials - miroslakkloze@yandex.ru
Loading...


Keywords: peugeot questions,justanswer,questions,just answer,answers,peugeot

Description: Question - Peugeot: low revs, cuts..operating temperature..2 pin sensor located - 4J. Find the answer to this and other Peugeot questions on JustAnswer.

Experience: Mechanical Engineer BEng Hons 22 years experience in car engine industry, 10 years in formula 1

This could be an airleak after the airflow meter, any air dragged in here isn't 'seen' by the ECU and so not compensated for and can lean the engine out and can also allow the engine to rev up when not desired causing rough running.

As its a mechanical fault it tends not to turn on the fault light and you can sometimes hear a 'hissing' noise with the engine running.

Check the hose clips for tightness and inspect the trunking for any cracks or splits and also all the vacuum system, the small bore pipes and fittings for cracks and missing parts.

The best way to locate a leak is to have the engine running and warm and then spray lighter gas /propane around each joint in turn. If the engine rev's up you've found your leak.

Work your way through each possible joint one at a time and you should find it. I use a slightly flattened piece of brake pipe and some rubber hose from the can of lighter gas to provide a spraying 'wand' and allow a direct blast of gas into each area, especially those difficult to reach with large implements.

It’s also worth getting the fuel pressure checked as if this is low due to a blocked filter or faulty regulator or even a poorly pump will all result in insufficient fuel being delivered to the engine

Might also be worth cleaning out the idle speed control motor / valve as these get clogged up with carbon and some brake cleaner washed through helps free things off.

Might also be worth checking the wiring and connector to the airflow meter for any signs of corrosion or damage. you can do a quick fault find if you unplug the meter and run the engine without it.

Air leaks are very temperature dependent as gaps can open or close up as things expand with heat, so they can be effected by the weather and engine temperature.

its also worth cleaning the airflow meter by removing it from the car and spraying the exposed sensor wires inside the tube with a brake or switch cleaner - ensure that the cleaner is one of the old fashioned, non Eco type that does not leave a residue



Photogallery Peugeot 206 16: